Asus TS100-E5/PI4 Manuel d'utilisateur télécharger pdf (Page 93)

ASUS TS100-E5/PI4 5-3

5.1.2 Installing hard disk drives

The motherboard supports Serial ATA hard disk drives. For optimal performance,

install identical drives of the same model and capacity when creating a disk array.

To install the SATA hard disks for a RAID conguration:

1. Install the SATA hard disks into the drive bays.

2. Connect the SATA signal cables.

3. Connect a SATA power cable to the power connector on each drive.

5.1.3 Setting the RAID item in BIOS

You must set the RAID item in the BIOS Setup before you can create a RAID

set(s). To do this:

1. Enter the BIOS Setup during POST.

2. Go to the Main Menu, select IDEConguration, then press <Enter>.

3. Select the item CongureSATAas, then press <Enter> to display the

conguration options.

4. Select RAID from the Congure SATA as item options, then press <Enter>.

5. Save your changes, then exit the BIOS Setup.

Refer to Chapter 4 for details on entering and navigating through the BIOS

Setup.

5.1.4 RAIDcongurationutility

Depending on the RAID_SEL1 jumper setting and the operating system, you can

select a utility to create a RAID set. Refer to section 3.2 Jumpers for details on the

RAID_SEL1 jumper settings.

Use the Intel

Matrix Storage Manager to create a RAID 0, RAID 1, RAID 10, or

software RAID 5 under Windows

Server operating system.

Use the LSI Logic Embedded SATA RAID Setup Utility to create a RAID 0,

RAID 1, or RAID 10 under Windows

Server or Red Hat

Linux operating system.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 165 166

Pas de commentaire

Asus TS100-E5/PI4 Manuel d'utilisateur Page 93