Asus TS100-E5/PI4 Manuel d'utilisateur Page 49

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 166
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 48
3-9ASUS TS100-E5/PI4
2. ICH7R Primary IDE connector (40–1 pin PRI_IDE1 and PRI_IDE3)–1 pin PRI_IDE1 and PRI_IDE3)1 pin PRI_IDE1 and PRI_IDE3)
The onboard IDE connector is for the Ultra DMA 133/100 signal cable. There
are three connectors on each Ultra DMA 133/100 signal cable: blue, black,
and gray. Connect the blue connector to the motherboard’s IDE connector,
then select one of the following modes to congure your device.
®
P5BV-C/4L/TS100-E5
P5BV-C/4L/TS100-E5
IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE1
PIN 1
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE3
PIN 1
Pin 20 on the IDE connector is removed to match the covered hole on
the Ultra ATA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
Use the 80conductor IDE cable for Ultra ATA 100/66/33 IDE devices.
Drivejumpersetting
Mode of
device(s)
Cable connector
Single device Cable-Select or Master - Black
Two devices
Cable-Select
Master
Black
Slave Gray
Master Master
Black or gray
Slave Slave
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
Vue de la page 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 165 166

Commentaires sur ces manuels

Pas de commentaire