Asus G1-P5G43 Manuel d'utilisateur télécharger pdf (Page 50)

4-8 Chapter 4: Motherboard info

6. IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable.

There are three connectors on each Ultra DMA 133/100/66 signal cable:

blue, black, and gray. Connect the blue connector to the motherboard’s IDE

connector, then select one of the following modes to congure your device.

• Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you

connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” ensure that all other device

jumpers have the same setting.

Drive jumper setting Mode of

device(s)

Cable connector

Single device Cable-Select or Master - Black

Two devices Cable-Select Master Black

Slave Gray

Master Master Black or gray

Slave Slave

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 77 78

Pas de commentaire

Asus G1-P5G43 Manuel d'utilisateur Page 50