Asus TXP4 Manuel d'utilisateur télécharger pdf (Page 24)

24 ASUS TXP4 User’s Manual

5. External Connectors

IMPORTANT: Connect ribbon cables such that the red stripe is on the pin 1 side of

the connector. The four corners of the connectors are labeled on the motherboard. Pin

1 is the side closest to the power connector on hard and floppy disk drives. IDE ribbon

cable must be less than 18in. (46cm), with the second drive connector no more than

6in. (15cm) from the first connector.

1. Keyboard Connector (5-pin female)

This connector supports either a standard IBM-compatible, 101/102-key, or 104-

key keyboard (Windows 95-compatible).

Keyboard Connector (5-pin female)

This motherboard accepts an AT Keyboard

Connector Plug as shown here.

Keyboard Connector

2. Floppy Disk Drive Connector (34-pin block )

This connector supports the provided floppy disk drive ribbon cable. After con-

necting the single end to the board, connect the two plugs on the other end to the

floppy disk drives. (Pin 5 is removed to prevent inserting in the wrong orien-

tation when using ribbon cables with pin 5 plugged).

Floppy Disk Drive Connector

Orient the red stripe to Pin 1

Pin 1

WARNING! Some pins are used for connectors or power sources. These are

clearly separated from jumpers as shown in the motherboard layout (page 12).

Placing jumper caps over these pins will damage your motherboard.

III. INSTALLATION

(Connectors)

III. INSTALLATION

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Pas de commentaire

Asus TXP4 Manuel d'utilisateur Page 24