Asus TXP4 Manuel d'utilisateur Page 31

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 60
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 30
ASUS TXP4 User’s Manual 31
III. INSTALLATION
(Power Connections)
III. INSTALLATION
Power Connection Procedures
1. After all jumpers and connections are made, close the system case cover.
2. Make sure that all switches are in the off position as marked by ° .
3. Connect the power supply cord into your computers power supply.
4. Connect the power cord into a power outlet that is equipped with a surge protector.
5. You may then turn on your devices in the following order:
a. Your monitor
b. External SCSI devices (starting with the last device in the chain)
c. Your system power. For ATX power supplies, you need to switch
on the power supply as well as press the ATX power switch on the
front of the case.
6. The power LED on the front panel of the system case will light. For ATX
power supplies, the system LED will light when the ATX power switch is
pressed. The monitor LED may light up after the system’s if it complies with
“Green” standards or if it has a power standby feature. The system will then
run power-on tests. While the tests are running, additional messages will ap-
pear on the screen. If you do not see anything within 30 seconds from the time
you turn on the power, the system may have failed a power-on test. Recheck
your jumper settings and connections or call your retailer for assistance.
7. During power-on, press <Delete> to enter the BIOS setup. Follow the instruc-
tions on the next section, “BIOS SOFTWARE.”
* Powering Off Your Computer: You must first exit or shut down your operat-
ing system before switching off the power switch. For ATX power supplies,
you can press the ATX power switch after exiting or shutting down your oper-
ating system. For Windows 95 users, you can click Shut down the computer?
from the Start button and the system will give three quick beeps after about 30
seconds and power off after Windows shut down.
NOTE: The message, It’s now safe to turn off your computer, will not be
shown in Windows 95 when using shut down with ATX power supplies.
Vue de la page 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 59 60

Commentaires sur ces manuels

Pas de commentaire