Asus M4N68T V2 Manuel d'utilisateur télécharger pdf (Page 18)

5. When the CPU is in place, push down the socket

lever to secure the CPU. The lever clicks on the side

tab to indicate that it is locked.

6. Install a CPU heatsink and fan following the

instructions that comes with the heatsink package.

You can also refer to section 1.6.2 Installing

heatsink and fan for instructions.

7. Connect the CPU fan cable to the CPU_FAN connector on the motherboard.

DO NOT forget to connect the CPU fan connector! Hardware monitoring errors can occur if

you fail to plug this connector.

3. Position the CPU above the socket such that the CPU

corner with the gold triangle matches the socket corner

with a small triangle.

4. Carefully insert the CPU into the socket until it ts in place.

The CPU ts only in one correct orientation.

DO NOT force the CPU into the socket to

prevent bending the pins and damaging the

CPU!

Gold triangle

Small triangle

2. Press the lever sideways to unlock the

socket, then lift it up to a 90°-100° angle.

Socket lever

Ensure that the socket lever is lifted up to a 90°-100°

angle; otherwise, the CPU will not t in completely.

CPU_FAN

CPU FAN PWM

CPU FAN IN

CPU FAN PWR

GND

M4N68T V2 Series CPU fan connector

M4N68T V2 Series

Chapter 1: Product introduction1-8

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 61 62

Pas de commentaire

Asus M4N68T V2 Manuel d'utilisateur Page 18