Asus P4SP-MX SE Manuel d'utilisateur télécharger pdf (Page 26)

1-18

Chapter 1: Product introduction

2. Floppy disk drive connector (34-1 pin FLOPPY1)

This connector supports the provided floppy drive ribbon cable. After

connecting one end to the motherboard, connect the other end to the floppy

drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables

with pin 5 plug).

1.10.2 Internal connectors

1. IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

This connector supports the provided UltraDMA133 IDE hard disk ribbon cable.

Connect the cable’s blue connector to the primary (recommended) or secondary

IDE connector, then connect the gray connector to the UltraDMA133 slave

device (hard disk drive) and the black connector to the UltraDMA133 master

device.

• Follow the hard disk drive documentation when setting the device in master

or slave mode.

• Pin 20 on each IDE connector is removed to match the covered hole on the

UltraDMA cable connector. This prevents incorrect orientation when you

connect the cables.

• The hole near the blue connector on the UltraDMA cable is intentional.

P4SP-MX SE

P4SP-MX SE IDE connectors

NOTE: Orient the red markings

on the IDE ribbon cable to

PIN 1

SEC_IDE1

PIN 1

PRI_IDE1

PIN 1

P4SP-MX SE

NOTE: Orient the red markings o

the floppy ribbon cable to PIN 1.

P4SP-MX SE Floppy disk drive connector

PIN 1

FLOPPY1

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 63 64

Pas de commentaire

Asus P4SP-MX SE Manuel d'utilisateur Page 26