Asus V2-PH2 Manuel d'utilisateur télécharger pdf (Page 38)

2-20

Chapter 2: Basic installation

2.9 Installing a ﬂoppy disk drive

The Vintage V2-PH2 system comes with one 3.25-inch drive bay for a

ﬂoppy disk drive.

To install a ﬂoppy disk drive:

1. Remove the front panel cover.

For instructions on how to remove the front panel cover, refer to page

2-3 of section “2.3 Removing the side cover and front panel assembly”.

2. Carefully insert the ﬂoppy disk drive into the ﬂoppy drive bay until the

screw holes align with the holes on the bay.

3. Secure the ﬂoppy disk drive with two screws on both sides.

4. Connect the ﬂoppy disk drive signal cable to the signal connector at

the back of the drive.

5. Connect the other end of the signal cable to the ﬂoppy disk drive

connector on the motherboard. See page 4-6 for the location of the

ﬂoppy disk drive connector.

6. Connect a 4-pin power cable from the power supply unit to the power

connector at the back of the ﬂoppy disk drive.

Floppy ribbon

cable

Power cable

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 101 102

Pas de commentaire

Asus V2-PH2 Manuel d'utilisateur Page 38