Asus V2-PH2 Manuel d'utilisateur Page 30
- Page / 102
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
2-12
Chapter 2: Basic installation
2.6 Expansion slots
In the future, you may need to install expansion cards. The following
sub-sections describe the slots and the expansion cards that they support.
2.6.1 Installing an expansion card
To install an expansion card:
1. Before installing the expansion card, read the documentation that
came with it and make the necessary hardware settings for the card.
2. Remove the system unit cover (if your motherboard is already
installed in a chassis).
3. Remove the bracket opposite the slot that you intend to use. Keep
the screw for later use.
4. Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
5. Secure the card to the chassis with the screw you removed earlier.
6. Replace the system cover.
Make sure to unplug the power cord before adding or removing
expansion cards. Failure to do so may cause you physical injury and
damage motherboard components.
2.6.2 Configuring an expansion card
After installing the expansion card, configure it by adjusting the software
settings.
1. Turn on the system and change the necessary BIOS settings, if any.
See Chapter 5 for information on BIOS setup.
2. Assign an IRQ to the card. Refer to the tables on the next page.
3. Install the software drivers for the expansion card.
- Vintage V2-PH2 1
- Second Edition V2 2
- March 2006 2
- Table of contents 3
- Safety information 7
- About this guide 8
- System package contents 10
- System introduction 11
- 1.2 Front panel 12
- 1.1 Welcome! 12
- ASUS Vintage V2-PH2 13
- 1.3 Rear panel 14
- Voltage selector 16
- 1.4 Internal components 17
- Basic installation 19
- 2.1 Preparation 20
- 2.2 Before you proceed 20
- panel assembly 21
- 2.4.1 Overview 22
- 2.4.2 Installing CPU 22
- 2.5 Installing a DIMM 26
- Qualified Vendors Lists (QVL) 27
- DDR2-533 27
- DDR2-667 28
- 2.5.3 Removing a DDR2 DIMM 29
- 2.5.2 Installing a DDR2 DIMM 29
- 2.6 Expansion slots 30
- 2.6.4 PCI slots 32
- 2.6.3 PCI Express x1 slot 32
- 2.6.5 PCI Express x16 slot 32
- Serial ATA cable 36
- Serial ATA power 36
- IDE ribbon cable 37
- Power cable 37
- Floppy ribbon 38
- 2.10 Re-connecting cables 39
- and side cover 40
- Starting up 41
- 3.3 Support CD information 42
- 3.2 Powering up 42
- 3.3.1 Running the support CD 43
- 3.3.2 Utilities menu 44
- 3.3.4 Manuals menu 45
- 3.3.3 Make Disk 45
- 3.4 Software information 46
- Installing PC Probe II 47
- Launching PC Probe II 47
- Using PC Probe II 47
- Preferences 48
- Hardware monitor panels 49
- WMI browser 50
- DMI browser 50
- PCI browser 51
- Configuring PC Probe II 52
- Motherboard info 53
- Chapter 4: Motherboard info 54
- 4.3 Jumpers 55
- Keyboard Power Setting 57
- 4.4 Connectors 58
- NOTE: Orient the red markings 59
- (usually zigzag) on the IDE 59
- CPU FAN IN 60
- CPU FAN PWM 60
- Right Audio Channel 61
- Left Audio Channel 61
- (Default) 63
- +5VSB_MB 63
- Chassis Signal 63
- Requires an ATX power supply 64
- BIOS setup 65
- DOS environment 66
- XP environment 66
- 2000 environment 66
- 5.1.2 ASUS EZ Flash utility 67
- 5.1.3 AFUDOS utility 68
- Updating the BIOS file 69
- 5.1.5 ASUS Update utility 72
- 5.2 BIOS setup program 75
- 5.2.2 Menu bar 76
- 5.2.1 BIOS menu screen 76
- 5.2.3 Navigation keys 76
- 5.3 Main menu 78
- Master/Slave 79
- 5.3.5 System Information 80
- 5.4 Advanced menu 81
- Legacy USB Support [Auto] 82
- BIOS EHCI Hand-off [Enabled] 82
- Overclocking [Auto] 83
- CPU Frequency [XXX] 83
- Memory Clock Mode [Auto] 84
- OverClock Memory Clock [XXX] 84
- 5.4.3 CPU Configuration 85
- Enhanced C1 Control [Auto] 86
- NorthBridge Configuration 87
- 5.4.4 Chipset 87
- Advanced NB 88
- SouthBridge Configuration 89
- Parallel Port Address [378] 90
- Parallel Port Mode [EPP+ECP] 90
- Parallel Port IRQ [IRQ7] 90
- 5.4.6 PCI PnP 91
- 5.5 Power menu 92
- 5.5.5 APM Configuration 93
- 5.5.6 Hardware Monitor 94
- CPU Voltage Selection 95
- Q-Fan Control [Disabled] 95
- 5.6 Boot menu 96
- 5.6.3 Security 98
- Change User Password 99
- 5.7 Exit menu 100
- Exit & Discard Changes 101
- Discard Changes 101
- Load Setup Defaults 101
- Chapter 5: BIOS setup 102
Produits connexes et manuels pour Ordinateurs Asus V2-PH2
Ordinateurs Asus BP1AE Manuel d'utilisateur
(99 pages)
(99 pages)
Ordinateurs Asus CM5570 Manuel d'utilisateur
(200 pages)
(200 pages)
Ordinateurs Asus CG8490 Manuel d'utilisateur
(356 pages)
(356 pages)
Ordinateurs Asus BP6375 Manuel d'utilisateur
(106 pages)
(106 pages)
Ordinateurs Asus M11BB Manuel d'utilisateur
(62 pages)
(62 pages)
Ordinateurs Asus BM6AE Manuel d'utilisateur
(113 pages)
(113 pages)
Ordinateurs Asus CM1630 Manuel d'utilisateur
(246 pages)
(246 pages)
Ordinateurs Asus CM6850 Manuel d'utilisateur
(198 pages)
(198 pages)
Ordinateurs Asus G50AB Manuel d'utilisateur
(83 pages)
(83 pages)
Ordinateurs Asus CM6731 Manuel d'utilisateur
(70 pages)
(70 pages)
Ordinateurs Asus CM6730 Manuel d'utilisateur
(200 pages)
(200 pages)
Ordinateurs Asus CG8890 Manuel d'utilisateur
(95 pages)
(95 pages)
Ordinateurs Asus CT1410 Manuel d'utilisateur
(202 pages)
(202 pages)
© 2020, manymanuals.fr. Tous droits réservés | 1.154 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels