Asus V6-P5G31E Manuel d'utilisateur télécharger pdf (Page 34)

3-6 Chapter 3: Motherboard info

3. IDEconnector(40-1pinPRI_IDE)

The onboard IDE connector is for the Ultra DMA 100/66 signal cable. There

are three connectors on each Ultra DMA 100/66 signal cable: blue, black, and

gray. Connect the blue connector to the motherboard’s IDE connector, then

select one of the following modes to congure your device.

• Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you

connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

If any device jumper is set as “Cable-Select,” ensure that all other device

jumpers have the same setting.

Drive jumper setting Modeof

device(s)

Cable connector

Single device Cable-Select or Master - Black

Two devices Cable-Select Master Black

Slave Gray

Master Master Black or gray

Slave Slave

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 69 70

Pas de commentaire

Asus V6-P5G31E Manuel d'utilisateur Page 34