Asus LSI SAS3442X-R Manuel d'utilisateur télécharger pdf (Page 59)

CFGGEN Commands A-11

The FORMAT command does not complete and return to a shell prompt

until the format operation is complete. This may take a long time for a

large disk drive.

Command Line –

cfggen <controller #> format <SCSI ID> [noprompt]

cfggen <controller #> format bay <enclosure:bay> [noprompt]

Parameters –

• <controller #> – Number of the controller targeted by this

command.

• Bay – This option indicates that enclosure:bay values are speciﬁed

instead of SCSI ID values.

• <SCSI ID> – SCSI ID of the hard disk drive to be formatted.

• <enclosure:bay> – The enclosure:bay value for the disk drive to be

formatted. These values can be obtained from the output of the

DISPLAY command.

• noprompt – Suppresses display of warnings and prompts.

Program Return Value –

0x00 SUCCESS: command completed successfully.

0x01 FAILURE: command failed.

A.3.6 HOTSPARE Command

The HOTSPARE command creates a hot spare disk drive. One or two

hot spare disk can be created per controller. The capacity of a hot spare

disk must be greater than or equal to the capacity of the smallest disk in

the logical drive. An easy way to verify this is to use the DISPLAY

command.

The following rules must be observed when creating hot spare disks:

1. A hot spare disk cannot be created unless at least one IM or IME

volume is already created.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 67 68

Pas de commentaire

Asus LSI SAS3442X-R Manuel d'utilisateur Page 59