Asus LSI SAS3442X-R Manuel d'utilisateur télécharger pdf (Page 54)

A-6 Using the CFGGEN IR Conﬁguration Utility

Parameters –

• <controller #> – Number of the SAS controller targeted by this

command.

• <volume type> – Volume type for the new volume to be created.

Valid values are IM or IME or IS.

• <size> – Size of the RAID volume in megabytes, or MAX for the

maximum size available.

• Bay – This option indicates that enclosure:bay values are speciﬁed

instead of SCSI ID values.

• <SCSI ID> – SCSI ID of a hard disk drive to be included in the RAID

volume.

• <enclosure:bay> – The enclosure:bay value for the disk drive to be

included in the RAID volume. These values can be obtained from the

output of the DISPLAY command.

• qsync – If this optional parameter is speciﬁed, a quick

synchronization of new volume will be performed. If the volume type

is IME or IS, a quick synchronization is always performed even if

qsync is not speciﬁed. A quick synchronization means that the ﬁrst

32-KB of the drives in the volume are cleared to 0.

• noprompt – Suppresses display of warnings and prompts.

Program Return Value –

0x00 SUCCESS: command completed successfully.

0x01 FAILURE: bad command line arguments or operational failure.

A.3.3 DEFAULTS Command

Note: This command is called DELETE in the EFI version of

CFGGEN.

The DEFAULTS (DELETE) command deletes any IM, IME, and IS

volumes and hot spare drives created by the CREATE and HOTSPARE

commands. No other controller conﬁguration parameters are changed.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 67 68

Pas de commentaire

Asus LSI SAS3442X-R Manuel d'utilisateur Page 54