Asus 1U Manuel d'utilisateur Page 90

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 172
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 89
5-245-24
5-245-24
5-24
Chapter 5: BIOS setupChapter 5: BIOS setup
Chapter 5: BIOS setupChapter 5: BIOS setup
Chapter 5: BIOS setup
DRAM Frequency [Auto]DRAM Frequency [Auto]
DRAM Frequency [Auto]DRAM Frequency [Auto]
DRAM Frequency [Auto]
Allows you to set the DDR operating frequency. Configuration options: [Auto]
[533 MHz] [667 Mhz]
Configure DRAM Timing by SPD [Enabled]Configure DRAM Timing by SPD [Enabled]
Configure DRAM Timing by SPD [Enabled]Configure DRAM Timing by SPD [Enabled]
Configure DRAM Timing by SPD [Enabled]
When this item is enabled, the DRAM timing parameters are set according to
the DRAM SPD (Serial Presence Detect). When disabled, you can manually set
the DRAM timing parameters through the DRAM sub-items. The following
sub-items appear when this item is Disabled.
Configuration options: [Disabled] [Enabled]
DRAM CAS# Latency [5 Clocks]
Controls the latency between the SDRAM read command and the time
the data actually becomes available.
Configuration options: [5] [4] [3]
DRAM RAS# to CAS# Delay [6 DRAM Clocks]
Controls the latency between the DDR SDRAM active command and the
read/write command. Configuration options: [2 DRAM Clocks]
[3 DRAM Clocks] [4 DRAM Clocks] [5 DRAM Clocks] [6 DRAM Clocks]
DRAM RAS# Precharge [6 DRAM Clocks]
Controls the idle clocks after issuing a precharge command to the DDR
SDRAM. Configuration options: [2 DRAM Clocks] [3 DRAM Clocks]
[4 DRAM Clocks] [5 DRAM Clocks] [6 DRAM Clocks]
DRAM RAS# Activate to Precharge [15 DRAM Clocks]
Configuration options: [4 DRAM Clocks] [5 DRAM Clocks] ~ [15 DRAM
Clocks]
Boots Graphic Adapter Priority [PEG/PCI]Boots Graphic Adapter Priority [PEG/PCI]
Boots Graphic Adapter Priority [PEG/PCI]Boots Graphic Adapter Priority [PEG/PCI]
Boots Graphic Adapter Priority [PEG/PCI]
Allows selection of the graphics controller to use as primary boot device.
Configuration options: [PCI/PEG] [PEG/PCI]
PEG Port ConfigurationPEG Port Configuration
PEG Port ConfigurationPEG Port Configuration
PEG Port Configuration
PEG Port [Auto]
Allows you to set or disable the PCI Express Graphic port.
Configuration options: [Auto] [Disabled]
Vue de la page 89
1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 171 172

Commentaires sur ces manuels

Pas de commentaire