Asus P5LD2-V Spécifications Page 54

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 144
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 53
2-302-30
2-302-30
2-30
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware information
9.9.
9.9.
9.
CPU, Chassis, and Power Fan connectorsCPU, Chassis, and Power Fan connectors
CPU, Chassis, and Power Fan connectorsCPU, Chassis, and Power Fan connectors
CPU, Chassis, and Power Fan connectors
(4-pin CPU_FAN(4-pin CPU_FAN
(4-pin CPU_FAN(4-pin CPU_FAN
(4-pin CPU_FAN
,,
,,
,
3-pin CHA_FAN2, PWR_FAN) 3-pin CHA_FAN2, PWR_FAN)
3-pin CHA_FAN2, PWR_FAN) 3-pin CHA_FAN2, PWR_FAN)
3-pin CHA_FAN2, PWR_FAN)
The fan connectors support cooling fans of 350 mA ~ 2000 mA (24 W
max.) or a total of 1 A ~ 3.48 A (41.76 W max.) at +12V. Connect the
fan cables to the fan connectors on the motherboard, making sure that
the black wire of each cable matches the ground pin of the connector.
The CPU_FAN and CHA_FAN2 connector supports the ASUS Q-Fan
feature.
Do not forget to connect the fan cables to the fan connectors. Insufficient
air flow inside the system may damage the motherboard components.
These are not jumpers! Do not place jumper caps on the fan connectors!
10.10.
10.10.
10.
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch cable
to this connector. The chassis intrusion sensor or switch sends a high-
level signal to this connector when a chassis component is removed or
replaced. The signal is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
P5LD2-V
®
P5LD2-V Chassis intrusion connector
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)
P5LD2-V
®
P5LD2-V Fan connectors
CPU_FANCHA_FAN2
PWR_FAN
GND
CPU FAN PWR
CPU FAN IN
CPU FAN PWM
GND
Rotation
+12V
GND
Rotation
+12V
CPU_FAN
CHA_FAN2
PWR_FAN
Vue de la page 53
1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 143 144

Commentaires sur ces manuels

Pas de commentaire