Asus P5LD2-V Spécifications télécharger pdf (Page 50)

2-262-26

2-26

Chapter 2: Hardware informationChapter 2: Hardware information

Chapter 2: Hardware information

4.4.

Serial ATA connectors (7-pin SATA1 [red], SATA2 [red],Serial ATA connectors (7-pin SATA1 [red], SATA2 [red],

Serial ATA connectors (7-pin SATA1 [red], SATA2 [red],

SATA3 [black], SATA4 [black])SATA3 [black], SATA4 [black])

SATA3 [black], SATA4 [black])

These connectors are for the Serial ATA signal cables for Serial ATA

hard disk drives.

If you installed Serial ATA hard disk drives, you can create a RAID 0,

RAID 1, RAID 5, or RAID 10 configuration with the Intel

Matrix

Storage Technology through the onboard Intel

ICH7R RAID controller.

Refer to Chapter 5 for details on how to set up Serial ATA RAID

configurations.

3.3.

ICH7R Primary IDE connector (40-1 pin PRI_IDE)ICH7R Primary IDE connector (40-1 pin PRI_IDE)

ICH7R Primary IDE connector (40-1 pin PRI_IDE)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra

DMA 100/66 signal cable has three connectors: a blue connector for

the primary IDE connector on the motherboard, a black connector for

an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),

and a gray connector for an Ultra DMA 100/66 IDE master device (hard

disk drive). If you install two hard disk drives, you must configure the

second drive as a slave device by setting its jumper accordingly. Refer

to the hard disk documentation for the jumper settings.

• Pin 20 on the IDE connector is removed to match the covered hole

on the Ultra DMA cable connector. This prevents incorrect insertion

when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

P5LD2-V

P5LD2-V IDE connector

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE

PIN 1

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 143 144

Pas de commentaire

Asus P5LD2-V Spécifications Page 50