Asus VINTAGE-AH1 Spécifications télécharger pdf (Page 38)

2-192-19

2-19

ASUS Vintage-AH1ASUS Vintage-AH1

ASUS Vintage-AH1

2.9 Installing a floppy disk drive

The Vintage-AH1 system comes with one 3.25-inch drive bay for a floppy

disk drive.

To install a floppy disk drive:

1. Remove the front panel cover.

For instructions on how to remove the front panel cover, refer to page

2-3 of section “2.3 Removing the side plates and front cover”

2. Carefully insert the floppy disk drive into the floppy drive bay until the

screw holes align with the holes on the bay.

3. Secure the floppy disk drive with two screws.

4. Connect the floppy disk drive signal cable to the signal connector at

the back of the drive.

5. Connect the other end of the signal cable to the floppy disk drive

connector on the motherboard.

6. Connect a power cable from the power supply unit to the power

connector at the back of the floppy disk drive.

Floppy ribbonFloppy ribbon

Floppy ribbon

cablecable

cable

Power cablePower cable

Power cable

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 102 103

Pas de commentaire

Asus VINTAGE-AH1 Spécifications Page 38