Asus VINTAGE-AH1 Spécifications télécharger pdf (Page 55)

4-64-6

4-6

Chapter 4: Motherboard infoChapter 4: Motherboard info

Chapter 4: Motherboard info

4.4 Connectors

2.2.

IDE connectors (40-1 pin PRI_IDE, SEC_IDE)IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra

DMA 100/66 signal cable has three connectors: a blue connector for

the primary IDE connector on the motherboard, a black connector for

an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),

and a gray connector for an Ultra DMA 100/66 IDE master device (hard

disk drive). If you install two hard disk drives, you must configure the

second drive as a slave device by setting its jumper accordingly. Refer

to the hard disk documentation for the jumper settings.

• Pin 20 on the IDE connector is removed to match the covered hole

on the Ultra DMA cable connector. This prevents incorrect insertion

when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

1.1.

Floppy disk drive connector (34-1 pin FLOPPY)Floppy disk drive connector (34-1 pin FLOPPY)

Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable.

Insert one end of the cable to this connector, then connect the other

end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection

when using a FDD cable with a covered Pin 5.

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

Floppy disk drive connector

PIN 1

FLOPPY

IDE connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

SEC_IDE

PRI_IDE

PIN 1 PIN 1

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 102 103

Pas de commentaire

Asus VINTAGE-AH1 Spécifications Page 55