Asus V2-PH1 Manuel d'utilisateur télécharger pdf (Page 56)

4-4

Chapter 4: Motherboard info

4.4 Connectors

2. IDE connector (40-1 pin PRI_IDE)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra

DMA 100/66 signal cable has three connectors: a blue connector for

the primary IDE connector on the motherboard, a black connector

for an Ultra DMA 100/66 IDE slave device (optical drive/hard disk

drive), and a gray connector for an Ultra DMA 100/66 IDE master

device (hard disk drive). If you install two hard disk drives, you must

conﬁgure the second drive as a slave device by setting its jumper

accordingly. Refer to the hard disk documentation for the jumper

settings.

• Pin 20 on the IDE connector is removed to match the covered hole

on the Ultra DMA cable connector. This prevents incorrect insertion

when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

1. Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided ﬂoppy disk drive (FDD) signal cable.

Insert one end of the cable to this connector, then connect the other

end to the signal connector at the back of the ﬂoppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection

when using a FDD cable with a covered Pin 5.

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

Floppy disk drive connector

PIN 1

FLOPPY

IDE connector

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE

PIN 1

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 103 104

Pas de commentaire

Asus V2-PH1 Manuel d'utilisateur Page 56