Asus AAM6000EV Manuel

Solwise Ltd. Quick setup instructions for Asus AAM6000EV ADSL Router (read these notes whilst also referring to the manual supplied w

Finally you must setup DNS Configuration on each PC: Each PC MUST have the address for DNS entered in it’s TCP setting. If your PC doesn’t have a D

8. Now drop into DOS (DON’T PANIC! Just do start/run enter ‘command’ and then click on OK) and at the ‘>’ command prompt type ‘ping’ followed by t

5. Firmware Upgrade To accomplish a firmware upgrade you will need the following software elements (it is assumed that you are using a standard

Enter the IP address of your router; the default address of the AAM6000EV is normally 192.168.1.1. (NOT as shown in the example above!!). Then click o

5.1.3. Booting the Router Now that you have the various software programmes (Terminal/BOOTP/TFTP) setup you are ready to boot the router and auto l

and the TFTP screen should show the file downloading... When the file download is finished the TFTP shows: and HyperTerminal clears to the logon

5.1.4. Activating the new Firmware After entering your user name and password (see above) the main setup screen appears: You now need to tell the r

When finished you are advised to reset to Factory Configuration (option 2.) however this will remove any custom programming/setup so you will have

- 2 -

Quick setup instructions for Asus AAM6000EV ADSL Router (read these notes whilst also referring to the manual supplied with the product) 1. Passwo

1. Passwords. Some levels of access in the firmware are password protected. Below shows the default password for the current firmware version: nam

3.2. Checking your TCP/IP settings The default IP address of the EV router is 192.168.1.1 on subnet mask 255.255.255.0. In simple terms this means tha

Click in ‘Enter’ to goto the configuration logon (or if you wait a few seconds this should happen automatically anyway). (Don’t worry that the exam

VCI : 38 For KC RapidTime Service Type : PPPoA Routed. Channel number : 1 VPI : 1 VCI

3.4.3. DNS Relay With ‘DNS Relay’ you tell your clients (PC’s) to send their DNS requests to the router (as against sending your requests through t

Goto Sys-Maintenance/User: To alter the default ‘adsl’ main user select EDIT for the ‘Action’ then enter the user number (1 for the first ‘adsl’ use