Asus VX97 Manuel d'utilisateur télécharger pdf (Page 12)

12 VX97 User’s Manual

III. INSTALLATION

7. Primary / Secondary IDE connectors (Two 40-pin Block)

These connectors support the provided IDE hard disk ribbon cable.

After connecting the single end to the board, connect the two plugs at the other

end to your hard disk(s). If you install two hard disks, you must configure the

second drive to Slave mode by setting its jumper accordingly. Please refer to the

documentation of your hard disk for the jumper settings. BIOS now supports

SCSI device or IDE CD-ROM bootup (see "HDD Sequence SCSI/IDE First" &

"Boot Sequence" in the BIOS Features Setup of the BIOS SOFTWARE).

TIP: You may configure two hard disks to be both Masters using one ribbon

cable on the primary IDE connector and another ribbon cable on the secondary

IDE connector. You may install one operating system on an IDE drive and

another on a SCSI drive and select the boot disk through BIOS Features Setup.

Connect the Red stripe to Pin 1

IDE (Hard Drive) Connectors

Primary IDE Connector

Pin 1

Secondary IDE Connector

8. IDE activity LED (IDE LED)

This connector supplies power to the cabinet’s IDE activity LED. Read and

write activity by devices connected to the Primary or Secondary IDE connectors

will cause the LED to light up.

IDE (Hard Drive) LED

TIP: If the case-mounted LED does not light,

try reversing the 2-Pin plug.

Hard Drive LED Lead

(Connectors)

III. INSTALLATION

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Asus VX97 Manuel d'utilisateur Page 12