Asus P4S333 Manuel d'utilisateur Page 60
- Page / 126
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
3-2
Chapter 3: Powering up
3.2 Vocal POST Messages
This motherboard includes the Winbond speech controller to support a
special feature called the ASUS POST Reporter™. This feature gives you
vocal POST messages and alerts to inform you of system events and boot
status. In case of a boot failure, you will hear the specific cause of the
problem.
These POST messages are customizable using the Winbond Voice Editor
software that came with your package. You can record your own
messages to replace the default messages.
Following is a list of the default POST messages and their corresponding
actions, if any.
POST Message Action
No CPU installed • Install an Intel Pentium 4
478/Northwood Processor into the
CPU socket.
System failed CPU test • Check the CPU if properly installed.
• Call ASUS technical support for
assistance. See the “ASUS contact
information” on page x.
System failed memory test • Install 184-pin unbuffered
DDR DIMMs into the DIMM
sockets.
• Check if the DIMMs on the DIMM
sockets are properly installed.
• Make sure that your DIMMs are
not defective.
• Refer to section “2.3 System
memory” for instruction on installing
a DIMM.
System failed VGA test • Install a PCI VGA card into one of
the PCI slots, or a 1.5V AGP card
into the AGP slot.
• Make sure that your VGA/AGP card
is not defective.
System failed due to CPU • In JumperFree mode, check your
over-clocking CPU settings in BIOS and make
sure you only set to the recom-
mended settings. See section “4.4
Advanced menu.”
• In jumper mode, refer to section
“2.7 Switches and jumpers.”
- Motherboard 1
- First Edition November 2001 2
- Contents 3
- FCC/CDC statements 6
- Safety information 7
- About this guide 8
- ASUS contact information 10
- Chapter 1 11
- 1.1 Welcome! 13
- 1.2 Package contents 13
- 1.3 Special features 14
- 1.3.2 Value-added solutions 15
- 1.4 Overview 16
- 20 21 22 23 17
- 2425262729 28 17
- (on LAN models only) 19
- (on audio models only) 19
- Chapter 2 21
- 2.1 Motherboard installation 23
- 2.2 Motherboard layout 24
- 2.3 Before you proceed 25
- 2.4.1 Overview 26
- 90 - 100 27
- Gold Mark 28
- Retention Module Base 29
- CPU Heatsink 29
- Retention Hole 30
- Retention Hook Snapped 30
- Retention Lock 30
- CPU Fan Connector 31
- (CPUFAN1) 31
- 104 Pins 32
- 2.5.2 Memory configurations 33
- 2.5.3 Installing a DIMM 34
- 2.6 Expansion slots 35
- 2.6.3 PCI slots 37
- 2.6.4 AGP slot 37
- P4S333 Advanced 38
- Communication Riser (ACR) 38
- 2.7 Switches and jumpers 39
- P4S333 Keyboard Power Setting 40
- P4S333 USB Device Wake Up 41
- (on audio models only) 42
- CPU Rise 0.2V 43
- 2.8 Connectors 44
- P4S333 IDE Connectors 45
- P4S333 Chassis Alarm Lead 46
- P4S333 12-Volt Fan Connectors 47
- +12V DC COM 48
- USB1USB2 49
- (optional) 50
- Power Supply Thermal Sensor 54
- P4S333 SIRQ1 Connector 55
- Chapter 3 57
- Award BIOS Beep Codes 59
- 3.2 Vocal POST Messages 60
- POST Message Action 61
- 3.3 Powering off the computer 62
- Chapter 4 63
- “Flashed 68
- Successfully” 68
- 4.2 BIOS Setup program 69
- 4.2.1 BIOS menu bar 70
- 4.2.2 Legend bar 70
- General help 71
- Scroll bar 71
- Sub-menu 71
- 4.3 Main Menu 72
- Type [Auto] 73
- [User Type HDD] 74
- SMART Monitoring [Disabled] 76
- PIO Mode [4] 76
- Ultra DMA Mode [Disabled] 76
- 4.3.2 Keyboard Features 77
- 4.4 Advanced Menu 79
- (for Willamette) 80
- (for Northwood) 80
- USB Legacy Support [Auto] 81
- 4.4.1 Chip Configuration 82
- PCI 2.1 Support [Enabled] 84
- Onboard PCI IDE Enable [Both] 84
- UART2 Use As [COM Port] 85
- Parallel Port Mode [ECP+EPP] 86
- ECP DMA Select [3] 86
- 4.4.3 PCI Configuration 87
- USB Function [Enabled] 88
- IRQ XX Reserved [No/ICU] 89
- 4.5 Power Menu 90
- 4.5.1 Power Up Control 92
- Power Up On USB [Disabled] 93
- Automatic Power Up [Disabled] 93
- 4.5.2 Hardware Monitor 94
- 4.6 Boot Menu 95
- Plug & Play O/S [No] 96
- Boot Up Floppy Seek [Enabled] 96
- 4.7 Exit Menu 97
- Load Setup Defaults 98
- Discard Changes 98
- Save Changes 98
- Chapter 5 99
- ASUS P4S333 motherboard 100
- 5.2 Support CD information 101
- 5.2.2 Installation menus 102
- 5.3 Software information 105
- 5.3.2 Winbond Voice Editor 107
- Changing the default language 108
- Advanced Button 111
- Mixer Icon 111
- Start from your desktop, then 112
- PCI Audio Applications/ 112
- Multi-Channel Audio Demo 112
- Help to display the 112
- Speaker Channel Configuration 112
- Glossary 113
- ASUS P4B333 motherboard 114
Produits connexes et manuels pour Matériel Asus P4S333
Matériel Asus 810E Manuel d'utilisateur
(136 pages)
(136 pages)
Matériel Asus M2N32-SLI Manuel d'utilisateur
(170 pages)
(170 pages)
Matériel Asus WL-160N Manuel d'utilisateur
(39 pages)
(39 pages)
Matériel Asus P5B-E Plus Manuel d'utilisateur
(158 pages)
(158 pages)
Matériel Asus M3A78-EM Manuel d'utilisateur
(108 pages)
(108 pages)
Matériel Asus K8V SE Manuel d'utilisateur
(140 pages)
(140 pages)
Matériel Asus P4PE BP Manuel d'utilisateur
(84 pages)
(84 pages)
Matériel Asus Z7S WS Manuel d'utilisateur
(156 pages)
(156 pages)
Matériel Asus M2N-MX SE Manuel d'utilisateur
(88 pages)
(88 pages)
Matériel Asus DELUXE P5LD2 Manuel d'utilisateur
(156 pages)
(156 pages)
Matériel Asus P5S800-VM Manuel d'utilisateur
(86 pages)
(86 pages)
© 2020, manymanuals.fr. Tous droits réservés | 2.004 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels