Asus Terminator P4 533A Manuel d'utilisateur télécharger pdf (Page 73)

ASUS Terminator P4 533A Barebone System

Floppy Disk Access Control [R/W]

When set to [Read Only], this parameter protects files from being copied to

floppy disks by allowing reads from, but not writes to, the floppy disk drive.

The default setting [R/W] allows both reads and writes. Configuration

options: [R/W] [Read Only]

Onboard Serial Port 1 [3F8H/IRQ4]

This field allows you to set the I/O address and IRQ assignment for the

onboard serial connector. Configuration options: [3F8H/IRQ4] [2F8H/IRQ3]

[3E8H/IRQ4] [2E8H/IRQ10] [Disabled]

Onboard Parallel Port [378H/IRQ7]

This field sets the address of the onboard parallel port connector. If you

disable this field, the Parallel Port Mode and ECP DMA Select

configurations are not available. Configuration options: [Disabled] [378H/

IRQ7] [278H/IRQ5]

Parallel Port Mode [ECP+EPP]

This field allows you to set the operation mode of the parallel port.

[Normal] allows normal-speed operation but in one direction only; [EPP]

allows bidirectional parallel port operation; [ECP] allows the parallel port to

operate in bidirectional DMA mode; [ECP+EPP] allows normal speed

operation in a two-way mode. Configuration options: [Normal] [EPP] [ECP]

[ECP+EPP]

ECP DMA Select [3]

This field allows you to configure the parallel port DMA channel for the

selected ECP mode. This selection is available only if you select [ECP] or

[ECP+EPP] in Parallel Port Mode above. Configuration options: [1] [3]

Onboard Game Port [200H-207H]

This field allows you to set the I/O address for the onboard game port.

Configuration options: [Disabled] [200H-207H] [208H-20FH]

Onboard MIDI I/O [Disabled]

This field allows you to set the I/O address for the MIDI device.

Configuration options: [Disabled] [330H-331H] [300H-301H]

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 97 98

Pas de commentaire

Asus Terminator P4 533A Manuel d'utilisateur Page 73