Asus T3-P5945GCX2 Manuel d'utilisateur télécharger pdf (Page 32)

2-16 Chapter 2: Basic installation

2.10 Replacing the power supply unit

Replace the power supply unit (PSU) after installing the system components and

reconnecting the cables.

To replace the PSU:

Make sure the PSU cables do not interfere with the CPU and/or chassis fans.

Voltage selector

The PSU has a 115 V/230 V voltage selector switch

located beside the power connector. Use this switch to

select the appropriate system input voltage according

to the voltage supply in your area.

If the voltage supply in your area is 100-127 V, set the

switch to 115 V.

If the voltage supply in your area is 200-240 V, set the

switch to 230 V.

Setting the switch to 115 V in a 230 V environment will seriously damage the

system!

REAR

S P K

LINE

FRONT

MIC IN

SIDE

S P K

C T R

BASS

1. If necessary, connect the 4-pin

12V power plug to the ATX12V

connector on the motherboard.

2. If necessary, connect the 24-pin

ATX power plug to the ATXPWR

connector on the motherboard.

3. Connect the optical drive power

connector.

4. Lift the PSU in the direction of the

arrow until it properly ts in place.

5. Secure the PSU with the screws

you removed earlier.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 79 80

Pas de commentaire

Asus T3-P5945GCX2 Manuel d'utilisateur Page 32