Asus Z8NA-D6 Manuel d'utilisateur Page 106

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 168
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 105
5-4 Chapter 5: RAID conguration
5.1.2 Installing hard disk drives
The motherboard supports Serial ATA for RAID set conguration. For optimal
performance, install identical drives of the same model and capacity when creating
a disk array.
To install the SATA hard disks for RAID conguration:
1. Install the SATA hard disks into the drive bays following the instructions in the
system user guide.
2. Connect a SATA signal cable to the signal connector at the back of each drive
and to the SATA connector on the motherboard.
3. Connect a SATA power cable to the power connector on each drive.
5.1.3 Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set
from SATA hard disk drives attached to the SATA connectors supported by
Intel
®
ICH10R chipset. To do this:
1. Enter the BIOS Setup during POST.
2. Go to the
Main Menu
>
IDE Conguration
, then press <Enter>.
3. Set
Congure SATA as
to [RAID]
4. Press <F10> to save your changes and exit the BIOS Setup.
Refer to Chapter 4 for details on entering and navigating through the BIOS
Setup.
5.1.4 RAID conguration utilities
Depending on the RAID connectors that you use, you can create a RAID set using
the utilities embedded in each RAID controller. For example, use the
LSI Logic
Embedded SATA RAID Setup Utility
or the
Intel
®
Matrix Storage Manager
if you
installed Serial ATA hard disk drives on the Serial ATA connectors supported by the
Intel
®
ICH10R chipset.
Refer to the succeeding section for details on how to use the RAID conguration
utility.
Vue de la page 105
1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 167 168

Commentaires sur ces manuels

Pas de commentaire