Asus RS926-E7/RS8 Manuel d'utilisateur Page 37
- Page / 200
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
2-15ASUS RS920-E7/RS8; RS926-E7/RS8
2.5 Expansion slot
2.5.1 Installing an expansion card to the riser card bracket
The barebone server comes with a riser card bracket. You need to remove the
bracket if you want to install PCI Express x16 expansion cards.
To install a PCI Express x16 card
4. Install a PCI Express x16 card to
the bracket as shown, and then
secure the card with a screw.
2. Place the riser card bracket on a
at and stable surface, and then
remove the screw from the slot bay.
PCI Express x16 slot
1. Loosen the screws of the riser card
bracket.
3. Loosen the screw of rear end
bracket and remove it.
- 2U Rackmount 1
- User Guide 1
- First Edition 2
- March 2012 2
- Contents 3
- REACH Information 8
- Safety information 9
- About this guide 10
- References 11
- Conventions 11
- Typography 11
- Product introduction 13
- 1.1 System package contents 14
- 1.2 Serial number label 15
- 1.3 Systemspecications 16
- 1.4 Front panel features 18
- 1.5 Rear panel features 18
- 1.6 Internal features 19
- 1.7 LED information 20
- 1.7.2 LAN (RJ-45) LEDs 21
- LAN5 LEDs 21
- LAN1 to LAN4 LEDs 21
- 1.7.3 HDD status LED 22
- Hardware setup 23
- 2.1 Chassis cover 24
- 2.2.1 Installing the CPU 25
- Chapter 2: Hardware setup2-4 26
- Triangle 27
- Chapter 2: Hardware setup2-6 28
- CPU Installation Sequence: 30
- 2.3 System memory 31
- 2.3.2 MemoryCongurations 32
- Locked Retaining Clip 33
- Unlocked retaining clip 33
- DIMM notch 33
- DIMM slot key 33
- 2.4 Hard disk drives 35
- PCI Express x16 slot 37
- GPU computing module bracket 38
- 2.6 Cable connections 40
- 2.8.1 System fans 42
- Heatsink bracket 45
- DO NOT remove the inner 46
- Installation options 49
- Fixing latch 50
- Latch screws 50
- Rail screws 50
- Rail Washers 50
- Motherboard info 55
- 4.1 Motherboard layout 56
- 4.2 Jumpers 58
- Management Controller 61
- 4.3 Internal connectors 62
- 4.4 Internal LEDs 72
- Q-Code table 75
- BIOS setup 77
- Drive Folder Info 79
- 5.1.3 BUPDATER utility 80
- Writing BIOS: 81
- 5.2 BIOS setup program 82
- 5.2.2 Menu bar 83
- 5.2.1 BIOS menu screen 83
- 5-8 Chapter 5: BIOS setup 84
- 5.3 Main menu 85
- 5.4 Advanced menu 86
- 5-12 Chapter 5: BIOS setup 88
- 5-14 Chapter 5: BIOS setup 90
- 5.4.3 ChipsetConguration 91
- 5-16 Chapter 5: BIOS setup 92
- Intel(R) I/OAT [Disabled] 94
- DCA Support [Enabled] 94
- VGA Priority [offboard] 94
- CPUIIOBridgeConguration 94
- DIMM Information 94
- 5.4.4 PCHSATAConguration 96
- SATA Mode [AHCI Mode] 97
- Staggered Spin-up [Disabled] 97
- 5.4.6 PCI Subsystem Settings 98
- 5.4.5 PCHSCUConguration 98
- 5-24 Chapter 5: BIOS setup 100
- Intel LAN Support 101
- Intel LAN4 Enable [Enabled] 102
- 5.4.8 USBConguration 103
- 5.4.9 Trusted Computing 104
- 5.4.10 ACPI Settings 105
- 5.4.11 WHEAConguration 106
- 5.4.12 APM setting 106
- Console Redirection Settings 107
- Console Redirection [Enabled] 108
- 5.4.14 ME Subsystem 110
- Advanced 111
- 5.5 Server Mgmt menu 112
- 5.5.1 System Event Log 113
- Station IP address [0.0.0.0] 114
- Subnet mask [0.0.0.0] 114
- Gateway IP address [0.0.0.0] 114
- 5.6 Event Logs menu 115
- View Smbios Event Log 116
- View System Event Log 116
- 5.7 Boot menu 117
- UEFI Boot [Disabled] 118
- Boot Option Priorities 118
- 5.8 Monitor menu 119
- 5.9 Security menu 120
- User Password 121
- Administrator Password 121
- 5.10 Tool menu 122
- 5.11 Exit menu 122
- 5-48 Chapter 5: BIOS setup 124
- RAIDconguration 125
- 6.1 Setting up RAID 126
- 6.2.1 Creating a RAID set 129
- Choose RAID Level For This VD 131
- Select Units For VD Size 132
- Select Yes Or No 133
- UsingNewConguration 134
- Using the Initialize command 136
- UsingtheObjectscommand 138
- BIOS Version A.10.09231523R 139
- Rebuild PD(s) 140
- Check Consistency 142
- Select VD 143
- 6.2.8 Enabling WriteCache 147
- 6.3 Intel 148
- Rapid Storage Technology 148
- 6.3.1 Creating a RAID set 150
- 6.3.3 Deleting a RAID set 153
- 6.3.6 Rebuilding the RAID 155
- 6.3.5 Exiting the Intel 155
- 6.4 Intel 158
- 6.4.1 Creating a RAID set 159
- 6.4.2 Change Volume Type 161
- 6.4.3 Delete volume 162
- 6.4.4 Preferences 163
- Driver installation 165
- 7.1 RAID driver installation 166
- LSI 2008 SAS2 Driver 167
- During Windows 168
- Server 2008 OS installation 168
- Enterprise Linux OS 5.6 170
- More Driver Disks? 171
- Do you wish to load any more 171
- Enterprise Linux OS 6.1 172
- Preparing the Linux Driver 175
- Installing SUSE 11 Linux OS 176
- <Enter> 177
- 7.2 Intel 179
- chipset device software 179
- 7.3 Intel 181
- 9. When nished, press 183
- to continue 183
- 7.4 VGA driver installation 184
- 8. Click 186
- 7.5 Intel 187
- 7.7 Intel 189
- 7.8 Intel 192
- 9. Click 195
- to nish the installation 195
- 7.9.2 Drivers menu 196
- 7.9.3 Utilities menu 197
- 7.9.4 Make disk menu 197
- 7.9.5 Contact information 197
- ASUS contact information 199
Produits connexes et manuels pour Matériel informatique Asus RS926-E7/RS8
(146 pages)
(112 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.043 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels