Asus RS260-E4/RX8 Manuel d'utilisateur Page 9
- Page / 182
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
ix
About this guide
Audience
This user guide is intended for system integrators and experienced users with at
least basic knowledge of conguring a server.
Contents
This guide contains the following parts:
1. Chapter 1: Product Introduction
This chapter describes the general features of the barebone server, including
sections on the front panel and rear panel specications.
2. Chapter 2: Hardware setup
This chapter lists the hardware setup procedures that you have to perform
when installing or removing system components.
3. Chapter 3: Installation options
This chapter describes how to prepare the barebone server for rack
mounting.
4. Chapter 4: Motherboard information
This chapter gives information about the motherboard that comes with the
server. This chapter includes the motherboard layout, jumper settings, and
connector locations.
5. Chapter 5: BIOS setup
This chapter tells how to change the system settings through the BIOS Setup
menus. Detailed descriptions of the BIOS parameters are also provided.
6. Chapter6:RAIDconguration
This chapter tells how to change system settings through the BIOS Setup
menus. Detailed descriptions of the BIOS parameters are also provided.
7 Chapter 7: Driver installation
This chapter provides instructions for installing the necessary drivers for
different system components.
8. Appendix: References
This appendix includes additional information that you may refer to when
conguring your barebone server.
- RS260-E4/RX8 1
- First edition V1 2
- November 2006 2
- Contents 3
- Appendix: References 6
- Safety information 8
- About this guide 9
- Conventions 10
- Reference 10
- Product introduction 11
- 1.1 System package contents 12
- 1.2 Systemspecications 13
- 1.3 Front panel features 15
- 1.4 Rear panel features 15
- 1.5 Internal features 16
- 1.6 LED information 17
- 1.6.2 System fan LED 18
- 1.6.3 Power supply LED 19
- 1.6.4 LAN port LEDs 19
- Hardware setup 21
- 2.1 Chassis cover 22
- 2.1.2 Removing the top cover 23
- Rear half 24
- ASUS RS260-E4/RX8 2-5 25
- 2.1.4 Removing the air duct 26
- ASUS RS260-E4/RX8 2-7 27
- 2.2.1 Installing a CPU 28
- Alignment key 29
- Gold triangle mark 29
- Load plate 29
- 2.3 System memory 31
- Rank population 32
- Memory Mirroring 33
- (Mirror) 34
- Memory Sparing 35
- Two DIMMs per channel 36
- Three DIMMs per channel 36
- 2.3.3 Installing a DIMM 37
- 2.3.4 Removing a DIMM 37
- 2.4 Hard disk drives 38
- ASUS RS260-E4/RX8 2-19 39
- 2.5 Expansion cards 40
- ASUS RS260-E4/RX8 2-21 41
- PCI cage pegs 42
- DSBF-D12/2U/SAS 43
- 2.5.5 Interrupt assignments 45
- 2.5.3 DDR2 SO-DIMM socket 45
- 2.6 Cable connections 46
- 2.6.1 Motherboard 47
- 2.6.2 SAS backplane 48
- 2.6.3 Fan boards 49
- 2.7 Removable components 50
- 2.7.2 Power supply modules 51
- ASUS RS260-E4/RX8 2-33 53
- 2.7.5 SAS backplane 55
- 2.7.6 System fan board 55
- 2.7.7 Power supply cage 57
- 2.7.8 LAN adapter (Optional) 58
- 2.7.9 LAN cable 58
- Installation options 59
- 3.1 Rackmount rail kit items 60
- ASUS RS260-E4/RX8 3-3 61
- 3.3 Attaching the rack rails 62
- ASUS RS260-E4/RX8 3-5 63
- 3.4 Rackmounting the server 64
- Motherboard info 65
- 4.1 Motherboard layout 66
- 4.1.2 Layout contents 67
- Heatsink hole 68
- Socket for CPU1 68
- Socket for CPU2 68
- ASUS RS260-E4/RX8 4-5 69
- 4.3 Jumpers 70
- DSBF-D12/2U/SAS VGA setting 72
- OFF(Default) 74
- 1 2 3 4 5 6 7 8 74
- 4.5 Connectors 75
- ADD_IN_CARD 76
- ASUS RS260-E4/RX8 4-13 77
- +3.3V Remote Sense 79
- I2C_7_DATA# 79
- I2C_7_CLK# 79
- 24-pin Power Connector 80
- +12V DC GND 80
- SATA_SCLK 82
- SATA_SLOAD 82
- SDATAOUT1 82
- SDATAOUT0 82
- ASUS RS260-E4/RX8 4-19 83
- AUX_PANEL1 84
- BIOS setup 87
- DOS environment 88
- XP environment 88
- Utility 89
- 5-4 Chapter 5: BIOS setup 90
- ASUS RS260-E4/RX8 5-5 91
- 5.2 BIOS setup program 92
- 4.2.2 Menu bar 93
- 5.2.1 BIOS menu screen 93
- 5.2.4 Menu items 94
- 5.2.5 Sub-menu items 94
- 5.2.6 Congurationelds 94
- 5.2.3 Legend bar 94
- 5.2.7 Pop-up window 95
- 5.2.8 General help 95
- 5.3 Main menu 96
- S-ATAConguration 97
- Native Mode Operation [Auto] 98
- Serial ATA [Enabled] 98
- Type [Auto] 99
- 5.3.6 SATA Port 1/2/3/4 100
- LBA Mode Control [Disabled] 101
- 32-Bit I/O [Disabled] 101
- Transfer Mode [Stadard] 101
- Ultra DMA Mode [Disabled] 101
- 5.3.7 System Information 102
- Processor Information 103
- System Memory Information 103
- 5.4 Advanced menu 104
- ASUS RS260-E4/RX8 5-19 105
- Echo TPR [Disabled] 106
- Intel EIST support [Disabled] 106
- 5.4.2 ChipsetConguration 107
- 5-22 Chapter 5: BIOS setup 108
- ASUS RS260-E4/RX8 5-23 109
- 5.4.3 PCIConguration 110
- PCI Device, Slot #1 ~ 6 111
- USB Function [Enabled] 112
- USB 2.0 Controller [Enabled] 112
- Legacy USB Support [Enabled] 112
- COM1 Port [Enabled] 113
- COM2 Port [Enabled] 113
- Parallel port [Enabled] 114
- 5.4.6 ACPIConguration 115
- 5.4.7 PowerOnConguration 116
- 5.4.8 Hardware Monitor 117
- 5-32 Chapter 5: BIOS setup 118
- CPU1/2 Target Temperature 119
- 5.5 Server menu 120
- ASUS RS260-E4/RX8 5-35 121
- Com Port Address 121
- item to 121
- 5.5.2 DMI Event Logging 122
- 5.6 Security menu 123
- Password Check [Setup] 124
- Password Lock Mode [Enabled] 124
- Flash Write [Enabled] 124
- 5.7 Boot menu 125
- 5.7.2 Boot Features 126
- 5.8 Exit menu 127
- Discard Changes 128
- Load Setup Defaults 128
- RAIDconguration 129
- 6.1 Setting up RAID 130
- ASUS RS260-E4/RX8 6-3 131
- LSI Logic Corp. MPT SAS BIOS 132
- Adapter(s) disabled by user 132
- ASUS RS260-E4/RX8 6-5 133
- Create and save new array? 137
- Cancel Exit 137
- Overview 138
- 6.2.4 Managing Arrays 141
- Managing hot spares 143
- Synchronizing the array 144
- Activating an array 145
- Deleting an array 145
- 6.2.5 Viewing SAS topology 146
- Selecting a boot disk 147
- 6.2.6 Global Properties 148
- Boot Information Display Mode 149
- Support Interrupt 149
- Restore Defaults 150
- Driver installation 151
- 7.1 RAID driver installation 152
- 2000/2003 Server OS 153
- To an existing Windows 155
- Enterprise 157
- ASUS RS260-E4/RX8 7-9 159
- SuSE Linux 160
- ASUS RS260-E4/RX8 7-11 161
- ASUS RS260-E4/RX8 7-13 163
- 7.3 LAN driver installation 165
- ASUS RS260-E4/RX8 7-17 167
- 9. When nished, press 168
- to continue 168
- ASUS RS260-E4/RX8 7-19 169
- 7.3.2 Red Hat/SuSE Linux 170
- 7.4 VGA driver installation 171
- 5. Select 172
- ASUS RS260-E4/RX8 7-23 173
- installation 174
- 7.5.4 Utilities menu 175
- 7.5.5 Contact information 175
- References 177
- A.1 Power supply 178
- A.1.2 Specications 179
- A.2 Troubleshooting 180
- Problem Action 181
- Appendix: ReferencesA-6 182
Produits connexes et manuels pour Matériel informatique Asus RS260-E4/RX8
(168 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.059 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels