Asus ESC2000 Personal SuperComputer Manuel d'utilisateur télécharger pdf (Page 100)

5-26 Chapter 5: BIOS setup

Plug And Play O/S [No]

When set to [No], BIOS congures all the devices in the system. When set to

[Yes] and if you install a Plug and Play operating system, the operating system

congures the Plug and Play devices not required for boot.

Conguration options: [No] [Yes]

PCI Option ROM Scan Order [Bus 0 First]

Allows you to select the PCI option ROM scanning order. The scanning of the

option ROM will start from the lowest bus, device, fucntion number if you set this

item to [Bus 0 First]; the scanning starts from the highest bus, device, function

number if you set this item to [Bus N First].

Conguration options: [Bus 0 First] [Bus N First]

Onboard Option ROM Priority [High]

Allows you to select the onboard option ROM priority.

Conguration options: [Normal] [High]

Onboard LAN1/2 Boot ROM [PXE]

Allows you to congure the onboard LAN1/2 boot mode.

Conguration: [Disabled] [PXE] [iSCSI]

5.4.6 APMConguration

APM Conguration

Restore on AC Power Loss [Last State]

Resume On Ring [Disabled]

Resume On PME#(Wake On LAN) [Disabled]

Resume On RTC Alarm [Disabled]

BIOS SETUP UTILITY

Advanced

Options

Power Off

Power On

Last State

Restore on AC Power Loss [Last State]

When set to [Power Off], the system goes into off state after an AC power loss.

When set to [Power On], the system will reboot after an AC power loss. When set

to [Last State], the system goes into either off or on state, whatever the system

state was before the AC power loss.

Conguration options: [Power Off] [Power On] [Last State]

Resume On Ring [Disabled]

When set to [Enabled], the system enables RI to generate a wake event while the

computer is in Soft-off mode. Conguration options: [Disabled] [Enabled]

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 187 188

Pas de commentaire

Asus ESC2000 Personal SuperComputer Manuel d'utilisateur Page 100