Asus RS926-E7/RS8 Manuel d'utilisateur télécharger pdf (Page 5)

Cache Vault Accessory Kit

Installing the Cache Vault Kit on specic

ASUS server systems

After installing the Cache Vault Falsh Module on the PIKE 2208 card, and installing

the Cache Vault Power Module on the steel CVPM clip and holder, install these two

assemblies to the specic ASUS server systems as instructed below.

Installing the kit on RS720-X7/RS8, RS720-E7/RS12, RS720-E7/

RS12-E server systems

1. Locate the two screw holes on the

right side of the server chassis.

2. Align the two screws on the side of

the steel CVPM holder installed with

the Cache Vault Power Module to

the two screw holes on the right side

of the server chassis. Secure the

holder assembly with two screws, and

connect the 42’’ cable extender to the

Cache Vault Power Module.

screw

locations

3. Connect the other end of the 42’’

cable extender to the Cache Vault

Flash Module that is installed on the

PIKE 2208 card.

4. Install the PIKE 2208 card into the

server system. Arrange the cable

extender in the direction of the arrows.

Installing the kit on TS700-X7/PS4, TS700-E7/RS8 server systems

1. Remove the chassis cover and lay

the system on its side on a at, stable

surface. Use a Phillip driver to remove

the screw on the metal slot cover and set

the screw aside. Remove the metal slot

cover.

Remove the metal slot cover close

to the bottom of the server chassis.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Asus RS926-E7/RS8 Manuel d'utilisateur Page 5