Asus P4PE Guide de l'utilisateur Page 45
- Page / 142
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
ASUS P4PE motherboard user guide
2-19
3. IDE connectors (40-1 pin IDE1, IDE2)
This connector supports the provided UltraDMA/100/66 IDE hard disk
ribbon cable. Connect the cable’s blue connector to the primary
(recommended) or secondary IDE connector, then connect the gray
connector to the UltraDMA/100/66 slave device (hard disk drive) and
the black connector to the UltraDMA/100/66 master device. It is
recommended that you connect non-UltraDMA/100/66 devices to the
secondary IDE connector. If you install two hard disks, you must
configure the second drive as a slave device by setting its jumper
accordingly. Refer to the hard disk documentation for the jumper
settings. BIOS supports specific device bootup. If you have more than
two UltraDMA/100/66 devices, purchase another UltraDMA/100/66
cable. You may configure two hard disks to be both master devices
with two ribbon cables – one for the primary IDE connector and
another for the secondary IDE connector.
1. Pin 20 on each IDE connector is removed to match the covered
hole on the UltraDMA cable connector. This prevents incorrect
orientation when you connect the cables.
2. The hole near the blue connector on the UltraDMA/100/66 cable is
intentional.
For UltraDMA/100/66 IDE devices, use an 80-conductor IDE cable.
The UltraDMA/66 cable included in the motherboard package also
supports UltraDMA/100.
P4PE
®
P4PE IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE
PIN 1PIN 1
PRI_IDE
- Motherboard 1
- First Edition 2
- September 2002 2
- Contents 3
- FCC/CDC statements 6
- Safety information 7
- About this guide 8
- ASUS contact information 10
- P4PE specifications summary 11
- Chapter 1 13
- 1.1 Welcome! 15
- 1.2 Package contents 15
- 1.3 Special features 16
- (on audio models only) 17
- 1.3.2 Value-added solutions 19
- 1.4 Motherboard overview 20
- (on RAID models only) 22
- (on LAN models only) 24
- Chapter 2 25
- 2.1 Motherboard installation 27
- 2.2 Motherboard layout 28
- 2.3 Before you proceed 29
- 2.4.1 Overview 30
- 90 - 100 31
- Gold Mark 32
- Retention Module Base 33
- CPU Heatsink 33
- Retention Hole 34
- Retention Hook Snapped 34
- Retention Lock 34
- CPU Fan Connector 35
- (CPU_FAN1) 35
- P4PE 184-Pin DDR DIMM Sockets 36
- 104 Pins 36
- SS - Single-sided DIMM 37
- DS - Double-sided DIMM 37
- 2.5.3 Installing a DIMM 38
- 2.5.4 Removing a DIMM 38
- 2.6 Expansion slots 39
- 2.6.3 PCI slots 41
- 2.6.4 AGP slot 41
- 2.7 Jumpers 42
- P4PE Clear RTC RAM 43
- 2.8 Connectors 44
- P4PE IDE Connectors 45
- P4PE SATA Connectors 47
- PRI_SATA 47
- SEC_SATA 47
- P4PE Chassis Alarm Lead 48
- CHASSIS1 48
- EZ_PLUG1 49
- P4PE 12-Volt Fan Connectors 50
- CPU_FAN1 50
- PWR_FAN1CHA_FAN1 50
- P4PE USB 2.0 Header 51
- (on 1394 models only) 53
- P4PE System Panel Connectors 55
- Chapter 3 57
- Award BIOS Beep Codes 59
- 3.2 Vocal POST Messages 60
- POST Message Action 61
- 3.3 Powering off the computer 62
- Chapter 4 63
- [BIOS Information in File] 66
- Flash Memory: SST 49LF004 66
- Creating a bootable disk 67
- Updating the BIOS 69
- “Flashed 70
- Successfully” 70
- 4.2 BIOS Setup program 71
- 4.2.1 BIOS menu bar 72
- 4.2.2 Legend bar 72
- General help 73
- Scroll bar 73
- Sub-menu 73
- 4.3 Main Menu 74
- Language [English US] 75
- Halt On [All Errors] 75
- Installed Memory [XXX MB] 75
- Type [Auto] 76
- [User Type HDD] 77
- SMART Monitoring [Disabled] 79
- PIO Mode [4] 79
- Ultra DMA Mode [Disabled] 79
- 4.3.2 Keyboard Features 80
- 4.4 Advanced Menu 81
- Memory Frequency [Auto] 82
- CPU VCore Setting [Auto] 82
- USB Legacy Support [Auto] 84
- 4.4.1 Chip Configuration 85
- (value depends on SDRAM SPD) 86
- Onboard PCI IDE [Both] 87
- UART2 Use As [COM Port] 88
- 4.4.3 PCI Configuration 90
- IRQ XX Reserved [No/ICU] 92
- 4.5 Power Menu 93
- 4.5.1 Power Up Control 95
- Automatic Power Up [Disabled] 96
- 4.5.2 Hardware Monitor 97
- 4.6 Boot Menu 99
- ASUS MyLogo2™ feature 100
- 4.7 Exit Menu 101
- Load Setup Defaults 102
- Discard Changes 102
- Save Changes 102
- Chapter 5 103
- Chapter summary 104
- 5.2 Support CD information 105
- 5.2.2 Drivers menu 106
- 5.2.3 Utilities menu 109
- Winbond Voice Editor 110
- ASUS Screen Saver 110
- E-Color 3Deep 110
- 5.2.5 Other information 111
- Technical Support Form 112
- Filelist 112
- 5.3 Software information 113
- 5.3.2 ASUS MyLogo2™ 114
- 5.3.3 ASUS PC Probe 116
- Monitoring 117
- CPU Cooling System Setup 118
- Information 119
- ASUS PC Probe Task Bar Icon 120
- 5.3.4 Winbond Voice Editor 121
- Changing the default language 122
- Adjusting the volume settings 126
- Headphone/ 127
- 2-Speaker 4-Speaker 6-Speaker 127
- 5.4.1 Install the hard disks 128
- No Array defined 130
- Performance 131
- Create Only 132
- Security 132
- Create and Duplicate 133
- Chapter 5: Software support 136
- ASUS P4PE motherboard 138
Produits connexes et manuels pour Cartes mères Asus P4PE
Cartes mères Asus VINTAGE-AH1 Spécifications
(113 pages)
(113 pages)
Cartes mères Asus M2N8-VMX Spécifications
(90 pages)
(90 pages)
(160 pages)
Cartes mères Asus SABERTOOTH Z77 Spécifications
(180 pages)
(180 pages)
Cartes mères Asus F2A55-M LK Spécifications
(78 pages)
(78 pages)
Cartes mères Asus Maximus II Gene Spécifications
(192 pages)
(192 pages)
(10 pages)
Cartes mères Asus P9X79 LE Spécifications
(176 pages)
(176 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.567 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels