Asus P2B-F Manuel d'utilisateur télécharger pdf (Page 37)

ASUS P2B-F User’s Manual 37

IV. BIOS SETUP

6. BIOS Setup

IV. BIOS

BIOS Setup

The motherboard supports a 5 Volt programmable Flash ROM chip, which can be

updated when BIOS upgrades are released. Use the Flash Memory Writer utility to

download the new BIOS file into the ROM chip as described in detail in this section.

All computer motherboards provide a Setup utility program for specifying the sys-

tem configuration and settings. If your motherboard came in a computer system, the

proper configuration entries may have already been made. If so, invoke the Setup

utility, as described later, and take note of the configuration settings for future refer-

ence; in particular, the hard disk specifications.

If you are installing the motherboard, reconfiguring your system or you receive a

Run Setup message, you will need to enter new setup information. This section

describes how to configure your system using this utility.

The BIOS ROM of the system stores the Setup utility. When you turn on the com-

puter, the system provides you with the opportunity to run this program. This ap-

pears during the Power-On Self Test (POST). Press <Delete> to call up the Setup

utility. If you are a little bit late pressing the mentioned key(s), POST will continue

with its test routines, thus preventing you from calling up Setup. If you still need to

call Setup, reset the system by pressing <Ctrl> + <Alt> + <Delete>, or by pressing

the Reset button on the system case. You can also restart by turning the system off

and then back on again. But do so only if the first two methods fail.

When you invoke Setup, the CMOS SETUP UTILITY main program screen will

appear with the following options:

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Pas de commentaire

Asus P2B-F Manuel d'utilisateur Page 37