Asus WL-160N Manuel d'utilisateur télécharger pdf (Page 29)

ASUS WLAN Adapter 29

Chapter 4 - Troubleshooting

Chapter 4

Troubleshooting

Cannot connect to a Station (WLAN Adapter)

Follow the procedure below to congure your WLAN Adapter.

a. Verify that the “Network Type” is in “Ad Hoc” mode.

b. Verify that the “SSID” of your WLAN Adapter is set to the same “SSID” of

the other station (or another WLAN Adapter).

c. Verify that the “channel” of the WLAN Adapter is “Auto” or set to the

same “channel” of the other station (or another WLAN Adapter).

d. Verify that the “Encryption” type is the same as the other station (or another

WLAN Adapter). If “WEP” encryption is enabled, you must set the same

“WEP” Keys on both stations.

Bad link quality or bad signal strength

There are two possible reasons. First is radio interference, keep the

environment around the WLAN Adapter away from microwave ovens and large

metal objects. Then try to reorient the WLAN Adapter antenna. Second is the

distance, decrease the distance between your WLAN Adapter and the access

point or station (or another WLAN Adapter).

The TCP/IP protocol did not bind to the WLAN PC Adapter.

This will occur when the computer already has six TCP/IP bindings in Windows

98 or ten bindings in Windows Me. These limits are imposed by the Microsoft

operating system.

Solution:

If your computer already has the maximum number of TCP/IP

bindings, remove one of the network adapters from the Network conguration

before installing the WLAN Adapter driver.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 38 39

Pas de commentaire

Asus WL-160N Manuel d'utilisateur Page 29