Asus M2N-XE Spécifications télécharger pdf (Page 36)

1-26 Chapter 1: Product introduction

3. Serial ATA connectors

(7-pin SATA1, SATA2)

These connectors are for the Serial ATA signal cables for Serial ATA

3.0 Gb/s hard disk and optical disk drives. The Serial ATA 3 Gb/s is

backward compatible with Serial ATA 1.5Gb/s specication.

The current Serial ATA I interface allows up to 150 MB/s data transfer

rate while Serial ATA II allows up to 300 MB/s data transfer rate,

faster than the standard parallel ATA with 133 MB/s (Ultra DMA133).

If you install Serial ATA hard disk drives, you can create a RAID

0, RAID 1, and JBOD conguration through the onboard NVIDIA

MediaShield™ controller.

Important note on Serial ATA

Install the Windows

2000 Service Pack 4 or the Windows

XP Service

Pack1 before using Serial ATA.

• For detailed instructions on how to congure RAID 0, 1, and

JBOD, refer to the RAID manual in the support CD.

• The RAID function of these connectors is set to [Disabled] by

default. If you intend to create a Serial ATA RAID set using these

connectors, enable the RAID Enabled item in the NVRAID

Conguration sub-menu in the BIOS. See section “2.4.3 Onboard

Device Conguration” for details.

M2N-MX SE

SATA Connectors

GND

RSATA_TXP2

RSATA_TXN2

GND

RSATA_RXP2

RSATA_RXN2

GND

SATA2

GND

RSATA_TXP1

RSATA_TXN1

GND

RSATA_RXP1

RSATA_RXN1

GND

SATA1

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 87 88

Pas de commentaire

Asus M2N-XE Spécifications Page 36