Asus G1-P5G43 Manuel d'utilisateur

G1-P5G43ASUS PC (Desktop Barebone)User’s Manual

x

System introductionThis chapter gives a general description of the ASUS G1-P5G43. The chapter lists the system features including introduction on the

1-2 Chapter 1: System introduction1.1 Welcome!Thank you for choosing the ASUS G1-P5G43!The ASUS G1-P5G43 is an all-in-one barebone system with a vers

1-3ASUS G1-P5G431.3 Rear panelThe system rear panel includes the power connector and several I/O ports that allow convenient connection of devices.1.

1-4 Chapter 1: System introduction Activity/Link Speed LEDStatus Description Status DescriptionOFF No link OFF 10 Mbps connectionORANGE Linked ORAN

1-5ASUS G1-P5G43Audio 2, 4, 6, or 8-channel congurationPortHeadset 2-channel4-channel 6-channel 8-channelLight Blue Line In Line In Line In Line InLi

1-6 Chapter 1: System introduction1.4 Internal componentsThe illustration below is the internal view of the system when you remove the left side cove

This chapter provides step-by-step instructions on how to install components in the system.Chapter 2Basic installation

2-2 Chapter 2: Basic installation 2.1 PreparationBefore you proceed, make sure that you have all the components you plan to install in the system.Bas

2-3ASUS G1-P5G432.3 Removing the side cover and front panel assemblyFollow the steps below to remove the side cover and front panel assembly.1.

iiCopyright © 2009 ASUSTeK Computer Inc. All Rights Reserved.No part of this manual, including the products and software described in it, may be repro

2-4 Chapter 2: Basic installation 2.4 Central Processing Unit (CPU)2.4.1 Overview2.4.2 Installing CPUTo install a CPU:1. Locate the CPU socket on

2-5ASUS G1-P5G43To prevent damage to the socket pins, do not remove the PnP cap unless you are installing a CPU.2. Press the load lever with your thu

2-6 Chapter 2: Basic installation 7. Close the load plate (A), then push the load lever (B) until it snaps into the retention tab.6. Apply Thermal I

2-7ASUS G1-P5G43If you purchased a separate CPU heatsink and fan assembly, make sure that the Thermal Interface Material is properly applied to the CP

2-8 Chapter 2: Basic installation 2.5 Installing a �IMM Installing a �IMM2.5.1 OverviewThe motherboard comes with four Double Data Rate 2 (DDR2) Dua

2-9ASUS G1-P5G432.5.2 Memory congurationsYou may install 512 MB, 1 GB, 2 GB, and 4 GB unbuffered non-ECC DDR2 DIMMs into the DIMM sockets.• You may

2-10 Chapter 2: Basic installation P5QPL-VM EPU Motherboard Qualied Vendors Lists (QVL) DDR2-1066MHz capabilityVendor Part No. SizeSS/DSBrand Chip NO

2-11ASUS G1-P5G43DDR2-800MHz capability(continued on the next page)Vendor Part No. SizeSS/DSBrand ChipNO.Timing DIMM (BIOS)VoltageDIMM SupportA* B* C*

2-12 Chapter 2: Basic installation DDR2 800MHz capabilityMHz capabilityVendor Part No. SizeSS/DSBrand ChipNO.Timing DIMM (BIOS)VoltageDIMM SupportA* B

2-13ASUS G1-P5G43DDR2 667MHz capabilityMHz capabilityVendor Part No. SizeSS/DSBrand ChipNO.Timing DIMM (BIOS)VoltageDIMM SupportA* B* C*A-Data M2OAD5H

iiiTable of contentsNotices ... viSafety informa

2-14 Chapter 2: Basic installation DDR2 667MHz capabilityMHz capabilitySS - Single-sided / DS - Double-sided DIMM support: • A*: Supports one module

2-15ASUS G1-P5G432.5.4 Removing a DDR2 DIMMFollow these steps to remove a DIMM.1. Simultaneously press the retaining clips outward to unlock the DIM

2-16 Chapter 2: Basic installation 2.6.1 PCI slotsThe PCI slots support cards such as a LAN card, SCSI card, USB card, and other cards that comply wi

2-17ASUS G1-P5G432.6.4 Installing an expansion cardTo install an expansion card:1. Before installing the expansion card, read the documentation that

2-18 Chapter 2: Basic installation 2.7 Installing storage drives2.7.1 Installing an optical drive2.7.2 Installing a hard disk drive1. Place the ch

2-19ASUS G1-P5G432.8 Reinstalling the front panel assembly and side coverTo reinstall the front panel assembly and side cover:1. Insert the front pa

2-20 Chapter 2: Basic installation

This chapter helps you power up the system and install drivers and utilities from the support DVD.Chapter 3Starting up

3-2 Chapter 3: Starting up3.1 Installing an operating systemThe barebone system supports Windows® XP/Vista operating systems (OS). Always install the

3-3ASUS G1-P5G433.3.1 Running the support DVDTo begin using the support DVD, place the DVD in your optical drive. The DVD automatically displays the

ivTable of contentsChapter 3: Starting up3.1 Installing an operating system ... 3-23.2 Powering up

3-4 Chapter 3: Starting up3.3.2 Utilities menuThe Utilities menu shows the applications and other software that the motherboard supports. ASUS InstAl

3-5ASUS G1-P5G433.3.3 ASUS Contact informationClick the Contact tab to display the ASUS contact information. You can also nd this information on the

3-6 Chapter 3: Starting upBrowse this DVDDisplays the support DVD contents in graphical format.FilelistDisplays the contents of the support DVD and a

This chapter gives information about he motherboard that comes with the system. This chapter includes the motherboard layout, jumper settings, and con

4-2 Chapter 4: Motherboard info4.1 IntroductionThe G1-P5G43 barebone system comes with an ASUS motherboard. This chapter provides technical informati

4-3ASUS G1-P5G434.3 Jumpers1. Clear RTC RAM (3-pin CLRTC)This jumper allows you to clear the Real Time Clock (RTC) RAM in CMOS. You can clear the CM

4-4 Chapter 4: Motherboard info2. USB device wake-up (3-pin USBPW1-6, USBPW7-12)Set the jumpers to +5V to wake up the computer from S1 sleep mode (CP

4-5ASUS G1-P5G434.3 ConnectorsDo not forget to connect the fan cables to the fan connectors. Insufcient air ow inside the system may damage the mot

4-6 Chapter 4: Motherboard info2. ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)These connectors are for ATX power supply plugs. The power suppl

4-7ASUS G1-P5G434. Serial ATA connectors (7-pin SATA1-6)These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.5. Opt

vTable of contents5.4 Advanced menu ... 5-115.4.1 CPU Conguration ...

4-8 Chapter 4: Motherboard info6. IDE connector (40-1 pin PRI_IDE)The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are t

4-9ASUS G1-P5G437. System panel connector (20-8 pin PANEL)This connector supports several chassis-mounted functions.• System power LED (2-pin PLED)T

4-10 Chapter 4: Motherboard info8. USB connectors (10-1 pin USB78, USB910, USB1112)These connectors are for USB 2.0 ports. Connect the USB module cab

4-11ASUS G1-P5G4310. Front panel audio connector (10-1 pin AAFP)This connector is for a chassis-mounted front panel audio I/O module that supports ei

4-12 Chapter 4: Motherboard info

BIOS setupThis chapter tells how to change system settings through the BIOS Setup menus and describes the BIOS parameters.Chapter 5

5-2 Chapter 5: BIOS setupSave a copy of the original motherboard BIOS le to a USB ash disk in case you need to restore the BIOS in the future. Copy

ASUS G1-P5G43 5-3Updating from a BIOS file a. Select Update BIOS from a le, then click Next. b. Locate the BIOS le from the Open window, then cl

5-4 Chapter 5: BIOS setup5.1.3 ASUS CrashFree BIOS The ASUS CrashFree BIOS is an auto recovery tool that allows you to restore the BIOS le when it f

ASUS G1-P5G43 5-55.2 BIOS setup programUse the BIOS Setup program to update the BIOS or congure its parameters. The BIOS screens include navigation

viSafety informationElectrical safety• To prevent electrical shock hazard, disconnect the power cable from the electrical outlet before relocating the

5-6 Chapter 5: BIOS setup5.2.2 Menu barThe menu bar on top of the screen has the following main items:Main For changing the basic system conguration

ASUS G1-P5G43 5-75.2.3 Navigation keysAt the bottom right corner of a menu screen are the navigation keys for that particular menu. Use the navigatio

5-8 Chapter 5: BIOS setup5.3 Main menuWhen you enter the BIOS Setup program, the Main menu screen appears, giving you an overview of the basic system

ASUS G1-P5G43 5-9LBA/Large Mode [Auto]Enables or disables the LBA mode. Setting to [Auto] enables the LBA mode if the device supports this mode, and i

5-10 Chapter 5: BIOS setup5.3.5 System InformationThis menu gives you an overview of the general system specications. The BIOS automatically detects

ASUS G1-P5G43 5-115.4 Advanced menuThe Advanced menu items allow you to change the settings for the CPU and other system devices.Take caution when ch

5-12 Chapter 5: BIOS setupThe following item appears only when you installed an Intel® CPU that supports the Enhanced Intel® SpeedStep® Technology (EI

ASUS G1-P5G43 5-13IGD Graphics Mode Select [Enabled, 32MB]Sets the IGD graphics mode. Conguration options: [Disabled] [Enabled, 32MB] [Enabled, 64MB]

5-14 Chapter 5: BIOS setupThe Module Version and USB Devices Enabled items show the auto-detected values. If no USB device is detected, the item shows

ASUS G1-P5G43 5-15USB Mass Storage Device CongurationUSB Mass Storage Reset Delay [20 Sec]Allows you to set the maximum time that the BIOS waits for

viiLithium-Ion Battery WarningCAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommend

5-16 Chapter 5: BIOS setup5.5 Power menuThe Power menu items allow you to change the settings for the Advanced Power Management (APM). Select an item

ASUS G1-P5G43 5-175.5.4 APM CongurationRestore on AC Power Loss [Power Off]When set to [Power Off], the system goes into off state after an AC power

5-18 Chapter 5: BIOS setupCPU Fan Speed [xxxxRPM] or [Ignored]The onboard hardware monitor automatically detects and displays the CPU fan speed in rot

ASUS G1-P5G43 5-195.6.1 Boot Device Priority1st ~ xxth Boot DeviceThese items specify the boot device priority sequence from the available devices. T

5-20 Chapter 5: BIOS setupBootup Num-Lock [On]Allows you to select the power-on state for the NumLock. Conguration options: [Off] [On]Wait For ‘F1’

ASUS G1-P5G43 5-21After you have set a supervisor password, the other items appear to allow you to change other security settings.User Access Level [F

5-22 Chapter 5: BIOS setup5.7 Tools menuThe Tools menu items allow you to congure options for special functions. Select an item then press <Enter

ASUS G1-P5G43 5-235.8 Exit menuThe Exit menu items allow you to load the optimal or failsafe default values for the BIOS items, and save or discard y

5-24 Chapter 5: BIOS setup

viiiConventions used in this guideWARNING: Information to prevent injury to yourself when trying to complete a task. CAUTION: Information to prevent d

ixSystem package contentsCheck your G1-P5G43 system package for the following items.If any of the items is damaged or missing, contact your retailer i